Rear Bumper, Polaris RZR XP® 1000 (24) Instructions For Models: RZR XP® 1000 (2024-2024)
1. Pre-install Support Tubes onto HMF Rear Bumper using supplied (2) M8-1.25x20, (2) 1/4” Flat Washers (See Figure #1)
2. Using (2) M8-1.25x25, (4) 1/4" Flat Washers and (2) m8-1.25 Nylock Nuts loosely hang the bumper on the machine using the upper mounting points. (See Figure #2)
3. Using (2) M8-1.25x25, (4) 1/4” Flat Washers and (2) M8-1.25 Nylock Nuts Loosely secure lower mounting points.(See Figure #3)
4. With all hardware and components in place, adjust and align the bumper and tighten all hardware.(See Figure #4)
Hook me up! Get 10% off your next exhaust or equipment order.
Sign up for the HMF Community and receive the following perks:
