For Models: Maverick R (2024-2024)
1. Carefully using a 1/8" drill bit, drill out the rivet heads on the lower facia valance then remove the (4) factory T40 Torx Bolts and remove the fascia. (See Figure #1)
2. Using a 5/16" drill bit, drill out the lowest rivet holes to allow for M8 bolts. (See Figure #2)
1. Using the supplied hardware (2) M8-1.25x25 Hexbolts, (4) M8 Flatwashers, (2) M8-1.25 Nylock nuts loosely hang the HMF LT front bumper by the winch plate. (See Figure #3)
2. Using the supplied hardware (2) M8-1.25x20 Hexbolts, (4) M8 Flatwashers, (2) M8-1.25 Nylock nuts loosely secure the lower mounting points of the LT Front Bumper. (See Figure #4)
3. At this time align HMF LT Front Bumper final placement and tighten all installed hardware. (See Figure #5)
4. Now install the Skid plate using (2) M8-1.25x20 Button head bolts, (4) M8 Flatwashers, M8-1.25 Nylock nuts on the upper (2) bolt holes and (2) M8-1.25x20 Button head bolts, (2) M8 Flatwashers, (2) M8-1.25 Flanged nuts on the (2) lower bolt holes. (See Figure #6)
NOTE: If installing LT Front bumper with a winch installed, use a magnet stick to place M8-1.25 Flange nut in lower mounting holes (See Figure #7)
5. Using the (4) Factory T40 Torx Bolts removed in Step 1 secure the wings of the Skid Plate to the factory mounting points of the Front Lower Fascia.(See Figure #8)
(See Figure #9)
Hook me up! Get 10% off your next exhaust or equipment order.
Sign up for the HMF Community and receive the following perks: