For Models: Maverick R (2024-2024)
Note : Remove and discard Shipping brackets and hardware before installation(See Figure #1)
1. Begin by inerting the welded stud of the HMF Rockslider into the rear upper mounting hole through the plastics and frame and loosely secureing using the provided (M10-1.25 Nylock nut and 3/8" USS Flatwasher) (See Figure #2)
2. With the rear of the HMF Rockslider supported by the frame mount, raise the front of the HMF Rockslider into position and insert the provided (M10-1.5x80 Hex bolt, 3/8" USS Flatwasher and Aluminium spacer) throught the access hole tworads the front of the vehicle and loosely start the bolt.(See Figure #3)
3. (NOTE: For the middle mounting point it is not required to remove the seats but will ease access to the mounting location) Slide both seats to their furthest foreward position, looking down through the seatbelt passege will show the location of the middle mount. Using the provided hardware (M10-1.5x80 Hex bolt, 3/8" USS Flatwasher and Aluminium spacer) loosely start the bolt by reaching behind the seat and watching through the seat belt passage.(See Figure #4)
(See Figure #5)
4. With all hardware loosely installed make any final alignment adjustments and tighten all hardware.(See Figure #6)
Hook me up! Get 10% off your next exhaust or equipment order.
Sign up for the HMF Community and receive the following perks: