- OR -

Exhaust Systems Can-Am® Outlander 1000

Print Instructions

HMF Racing Full System Exhaust Instructions

For Models: Outlander 1000 (2012-2023)

Removal

1. Loosen the Stock Clamp and remove the Silencer Mounting Bolts and Silencer.(See Figure #1)

Full System Exhaust Instructions - Figure 1

2. Remove the (3) Bolts and Plastic Bolt located in the trunk. 

3. MODELS WITH REAR BUMPER Remove the Left Lower Bumper Mounting Bracket (See Figure #2)

Full System Exhaust Instructions - Figure 2

4. Remove the Seat

5. Remove the Gauge Panel Cluster and Upper Plastic Air Box Cover.

6. Remove the Left and Right Side Plastic Body Panels.

7. Remove the Head Pipe Heat Shield.  Removal may be easier with the Battery Box Tray raised up. Do not damage the heat shield, as it will be reused on the installation.

8. Remove the Stock Head Pipe.

Installation

1. Be sure that the rear head pipe to the cylinder head gasket is installed.  (replace if worn)  Install the rear head pipe section and nuts hand tight.

2. Be sure that the front head pipe to the cylinder head gasket is installed.  (replace if worn)    Install the front head pipe section into the collector while lining up the collar with the exhaust port in the head.   Some pushing and twisting may be necessary as this is a snug fit.  Install nuts hand tight.

3. Install the supplied bracket using the (3) supplied M6 bolts, washers, and original nyloc nuts.  (Top right bolt will not use a nyloc nut.  It will thread into the OE nut-sert clip.)  Use the supplied M8 bolt, washers and nyloc nut on the front bracket hole. (See Figure #3)

Full System Exhaust Instructions - Figure 3

2. Slide the supplied Clamp over the Silencer Inlet. 

4. Use the supplied hardware to mount the Silencer to the previously installed bracket.  Do not tighten.

5. Ensure proper exhaust alignment and clearance.

6. Tighten the Silencer Mounting Bolts, clamp, and Head Pipe Nuts

7. Install the supplied Heat Shield where necessary.

8. Full System Only: Reinstall the Head Pipe Heat Shield, Left and Right Side Plastic Body Panels, Upper Plastic Air Box Cover, Gauge Panel Cluster, and Seat.

9. Reinspect all areas around the exhaust system for proper alignment and clearance. 

Discussion

Hook me up! Get 10% off your next exhaust or equipment order.

Sign up for the HMF Community and receive the following perks:

  • 10% off your next exhaust or equipment purchase
  • Details about upcoming HMF products
  • Exclusive product giveaways

Tell us your vehicle for 10% off!

Sign Me Up!

No, thanks. I'll pay full price for my powersports needs.