HD Front Bumper, Polaris RZR Turbo R/4 Instructions

Installation

1. Remove stock front bumper and trim plastics.(See Figure #1)

2. Install Front Middle Mounting Plate using factory bolts and provided M8x50 Bolts, Aluminium Spacers and Lock Nuts, leave bolts loose.(See Figure #2)

3. Place OEM trim panels inside Front Bumper. Hang Bumper using 2 lower factory bolts and leave loose. (See Figure #3)

4. Attach Bumper to Front Middle Mounting Plate using provided M8x20 Bolts, ¼” Flat Washers and Lock Nuts. Leave bolts loose.(See Figure #4)

5. Align Bumper, Middle Mounting Plate and tighten factory mounting bolts. Tighten M8x20 Bolts between Bumper and Middle Mounting Plate.

6. Reinstall 4 outer trim panel bolts. (See Figure #5)

-----------------------------------------------------------------------------------------------------------------

If also using HMF Winch Mount assembly
Use the hardware provided with the HMF Winch Mount Assembly for installation. (Mounting plate from bumper and dogbone lower mount from winch will not be used in this installation)

1. Remove stock bumper and trim plastics(See Figure #6)

2. Pre install winch on Front Bumper Winch Mounting Plate. Install Front Bumper Winch Mounting Plate on vehicle using factory upper bumper mounts. Do not tighten. (See Figure #7)

3. Attach lower grill to Front Bumper Winch Mounting Plate using provided M8x20 Button-head Allens, ¼” Flat Washers and Lock Nuts. (See Figure #8)

4. Remove center trim panel from front trim panel assembly and place outer trim panel inside Front Bumper.(See Figure #9)

5. Hang Front Bumper with factory lower bumper hardware. Do not tighten.

6. Install supplied M8x20 allen bolts, ¼” flat washers and lock nuts between Front Bumper and Front Bumper Winch Mounting Plate. Leave loose.(See Figure #10)

7. Slide supplied Aluminum Center Trim Panel in from the side of Front Bumper and reinstall using factory center trim hardware. Note : Leaving front outer trim panel unbolted and loose will allow movement to reinstall factory center trim bolts.(See Figure #11)

8. Insert Front Winch Plate through opening of Front Bumper and secure to Front Bumper using supplied M8x30 allen bolts, M8x20, ¼” Flat Washers and Lock Nuts. (See Figure #12)

9. Align and tighten upper and lower bumper mount hardware.(See Figure #13)

10. Tighten hardware between Front Bumper and Front Bumper Winch Mounting Plate.(See Figure #14)

11. Reinstall factory Outer trim panel hardware.