Rock Sliders, Polaris RZR XP^® 1000 (24-25) Instructions

Installation

1. Remove (4) T40 Torx bolts from rocker panel (2) on the side and (2) in the front wheel well and partially pull the skid plate down. (See Figure #1)

2. Repeat for the other side of the vehicle. 

3. On both Rock Sliders pre assemble Tube Anchor Wedge, 5/16” Aluminum Spacer and M10-1.5x 60 Hex Bolts onto the center mount of each Rock Slider.(See Figure #2)

3. Place remaining 5/16” Aluminum Spacers into front Frame Tube Openings.(See Figure #3)

4. Place 1-1/4” Aluminum Spacer into the Frame Tube Opening in the Rear Wheel Well. (See Figure #4)

5. Using M10-1.5x 100 Hex bolt and 3/8" Flat washer in the forward mount hang the Rock Slider on the vehicle.(See Figure #5)

6. Using M10-1.5 Nylock and 3/8” Fender Washer loosely secure front mount.(See Figure #6)

7. With remaining M10-1.5x.120 Hex Bolt, 3/8" Flat Washer and 3/8" Fender Washer secure the rear mounts.  
Repeat above steps for the other side of the vehicle.(See Figure #7)

8. With all Hardware and Components in place make final alignment adjustments and tighten all hardware 
Resecure the skid plate.